Questions & Answers for: HP LaserJet where is the paper output tray

...paper jam output tray.( on top of the printer ). The roller under the topcover is turning the wrong way. The paper can't get out of the printer, and jams between the upper roller and the fuser. ...

...paper output bin. Do not allow more than 125 sheets of 20-lb (75 g/m2) bond weight paper to fill the paper output bin (less for heavier paper). The pickup roller or printer separation pad might be ...

...Printer P2015d is blinking. The printer will not print the figure 8 light means paper jam. check all of the paper path, from the paper try to the output, and fromt the manual feed tray to the

paper has got into the fuser and cannot get into the output bin. Few things... 1. Clean output rollers. Are rollers moving? 2. Check gears on the fuser unit. Any broken or worn gears? 3. Check default

was jammed so that even though there was no paper in the output tray the printer believed the tray was full. Fixing the jam didn't reset the printer, however, so it was necessary to reboot the printer

...paper output bin. Do not allow more than 125 sheets of 20-lb (75 g/m2) bond weight paper to fill the paper output bin (less for heavier paper). The pickup roller or printer separation pad might be ...

...paper jams or wrinkled output. Symptoms are as follows: The pickup roller will spin and try to pick paper. The paper will partially feed into the product accompanied by a crackling, crunching noise ...

...paper tray, and the output door, and rotate the green levers down. At this point, you might be able to remove the jammed paper. If not, remove the toner cartridge. Grasp the page in both hands and ...

...paper and try again also the output tray full sensor is probably covered in dust/paper debris- removing the top cover will reveal the position of the sensor connected to the actuator arms clean and ...

...output bin. Printing resumes automatically. Take a close look at the flaps hanging out the exit of the printer. They should move up and down freely. If one of them is stuck up, broken or dislodged, ...