...In the Admin section, there are areas to specify output trays. It is either in the paper tray area or the fax and print setup. It can deffinately be done, depending on the model as to where it
Question about bizhub 350 All-In-One Laser Printer
...Paper Multiple-in-1 and Booklet Copy Zoom Auto Panel Reset Energy Save Mode User?s Choice Mode User?s Choice 3/6 Plug-In Counter,ID Key Reset Auto Power Off LCD Back-light Off 4in1 Copy Order Density ...
Question about bizhub 250 All-In-One Laser Printer
paper to print faxes on when the are received. We can select an output tray - but selecting tray 2 will put too much added stress to the finisher motor. How can we tell the machine to always pull from
Question about magicolor 2300DL Laser Printer
Need the rest tray for Konica Minolta magicolor 2430DL at the paper output on top. purchase it from the dealer, or place a piece of cardboard there which can also work the same.
...Paper Lift failure of the finisher output tray. Did some one hit the finisher tray or did it hit something underneath? May require resetting the position of the finisher output tray, get qualified ...
Question about Bizhub c203 Copier
paper color settings in menus on c203 and the color density output is perfect. (I lied and told the 203 that we have thick paper in the trays.) of course, now i cannot fold and staple. i have searched
Question about Bizhub c203 Copier
...a loud "gears stripping" noise when it prints, additionally, the paper gets jammed when entering the output tray, can you help..thank you does it jam in middle section or as it exit the output ...
...paper in the output tray, the printer immediately goes into an error state and indicates "Media Jam Fuser" on the screen. simply opening the front cover appears to clear the error message. But the ...
top output tray in the middle are four orange rollers when properly cleaned. well the top two and bottom should seperate when paper comes out, there is a problem with that get a tech out to look at it
Question about Bizhub c203 Copier
...paper doesnt get pushed through to the output tray. If this is the case then you will need to replace the exit roller drive motor and possible the PRCB too as sometimes when the motor becomes faulty ...
Usually answered in minutes!
1,023 Questions
924 Questions
417 Questions
321 Questions
302 Questions