Questions & Answers for: paper feed calculator

Question about P170-DH Calculator

1 Answer

...is a slip slid paper in that Press the feed key and allow the paper to feed through the claculator if it doesn't feed through push the paper in a little and hit the feed key again. It worked for ...

Ad

Question about P170-DH Calculator

1 Answer

straight across. Then feed the paper into the slot in the back of the calculator. Turn the calculator on to the print mode. Then hit the "feed" button. The paper will feed thru and you are ready to go

Ad

...feed the paper through Replacing the paper roll involves feeding the evenly cut, uniform end of the roll through the fine slot located under the paper arm at the back of the calculator. (Even if the ...

Question about P23-DH Calculator

1 Answer

...paper. Feed the end of the paper through the rear slot, and then into the internal feed slot, and hold the [FEED] key. After that, you can flip the arm back to mount the roll and replace the upper ...

Question about P23-DHV Calculator

1 Answer

...feed the paper through to start printing Put paper on paper arm with end of paper hanging down from the back. Cut the end of the paper at a diagonal. Insert paper into **** on back of calculator. Use ...

Question about HR-8TMPlus Calculator

1 Answer

...a straight clean edge. Feed the paper into the slot in the back - make sure the paper is straight. Paper will go in about 1/4 inch. Push the feed button and the paper should feed through the

Question about P23-DH Calculator

1 Answer

feed the paper into the slot in the back of the calculator. Turn the calculator on to the print mode. Then hit the "feed" button. The paper will feed through and you are ready to go. Hopes this helps

...cut edge of the paper into the small **** at the back of the calculator. 4 Press the feed button in the upper left area of the calculator's keyboard to feed the paper roll up through the

Question about P23-DHV Calculator

1 Answer

...paper feed roller is not properly connected. Make sure that the paper feed roller is securely connected to the calculator and that the power switch is in the "on" position. If the problem persists, ...

...feed the paper Here are some steps you can try to fix the issue: Check the paper: Make sure you're using the correct type of paper for your calculator. The FR-2650A requires 2 1/4 inch (57mm) wide ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Office Equipment & Supplies Experts

k24674

Level 3 Expert

8093 Answers

Brad Brown

Level 3 Expert

19187 Answers

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

66944 Answers

Are you an Office Equipment & Supplies Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...