paper feed when the paper feed key is depressed ?? 1. Lift the paper holder up. 2. Fold the leading edge of the paper roll 3 to 5 cm. (Do not fold it slantwise.) 3. Insert the paper roll from the left
paper feed when the paper feed key is depressed ?? 1. Lift the paper holder up. 2. Fold the leading edge of the paper roll 3 to 5 cm. (Do not fold it slantwise.) 3. Insert the paper roll from the left
...Paper Feed The paper no longer will feed into my Sharp AL-800 copier. It appears the wheels are not even turning on the back of the unit. Paper just sits and the "P" light come on. Removal and ...
paper gets feed in, I usually use this trick to start a new roll of paper. First, tear off the end of the new roll so that there isn't any glue stuck on the paper. Then, fold the tip of the paper like
...paper feed problem, try taking some rubbing alchoial and clean the ADF paper feed tires, This helps the paper to feed into the scanner unit so the fax can be sent. I have also seen part of the ADF ...
Question about EL-1801C Calculator
...feed the paper through Replacing the paper roll involves feeding the evenly cut, uniform end of the roll through the fine slot located under the paper arm at the back of the calculator. (Even if the ...
feed the paper. Since this is a rear feed machine sometimes things can fall into the paper feed slot so I would remove the paper and look into the port where the paper goes. Also while your there look
...feed the paper into the adding machine. It's a EL-2615G. thanks! Fold the leading edge of the paper roll 3 to 5 cm. (Do not fold it slantwise.) Insert the paper roll from the left side of the paper ...
...feed. Do not tear the paper roll, as feeding a torn paper roll can cause a paper jam. 3 Insert the cut edge into the paper opening on the back of the Sharp EL-1801V. Hold the paper roll so that the ...
Question about Mx2600n Color Copier, Printer, Scanner
...feed issue or paper detect issue. There are 2 little black photo reflectors before the rollers in the centre of the feed path. These sensors can get covered with paper dust & may need cleaning. ...
Usually answered in minutes!
1,105 Questions
603 Questions
557 Questions
331 Questions
354 Questions