Questions & Answers for: oxygen sensor cleaner

oxygen sensor in banks 1 and 2 detected a rich condition (too little oxygen in the exhaust). A code P0172 may mean that one or more of the following has happened: · The MAF (Mass Air Flow) Sensor

Ad

oxygen sensor?? No the oxygen sensor is located in the exhaust manifold up stream from the converter lessening the back pressure will only make more movement of air and a cleaner burn from your engine

Ad

Question about 1996 Thunderbird LX

2 Answers

...oxygen sensor (cannot repair open or short that occurs internally to sensor) A code P0155 is same issue as above only it affects Bank 2, Sensor 1 A code P0172 basically means that an oxygen sensor in ...

...oxygen sensor in bank 1 detected a rich condition (too little oxygen in the exhaust). On V6/V8/V10 engines, Bank 1 is the side of the engine that has cylinder #1. Note: This DTC is very similar to ...

Question about 1997 Escort

1 Answer

...oxygen sensor on the exhaust to establish the correct fuel air ratio. If the oxygen sensor is not working the computer continues as if the engine is in still 'open loop' mode. First check the ...

Question about 2004 Impala

1 Answer

oxygen sensor operation (Tip: The oxygen sensor in front of the catalytic converter normally has a fluctuating waveform. The waveform of the sensor behind the converter should be more steady). Inspect

oxygen sensor in bank 1 detected a rich condition (too little oxygen in the exhaust). On V6/V8/V10 engines, Bank 1 is the side of the engine that has cylinder #1 A code P0172 may mean that one or more

Question about 2001 Grand Cherokee

1 Answer

...Oxygen Sensor Heater Bank 1 Sensor 2" Have this Error Message coming up,.. where is it located and how difficult is it to repair? It is the oxygen sensor on the exhaust pipe past the catalytic ...

...oxygen sensor upstream the catalytic converter on Bank 2. This code indicates the engine air fuel ratio is not being adjusted by the oxygen sensor signal or the ECM as expected to do so, or not ...

...oxygen sensor is faulty The wiring to the sensor is broken / frayed There is an exhaust leak Possible Solutions The simplest thing to do is to reset the code and see if it comes back. If the code ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...