Questions & Answers for: overtemp

...exhaust heat, is it installed with the proper clearances? it is one, not venting and tripping the overtemp, two, the overtemp module is bad, or the board receiving the signal is ...

...thermal fuse is good, never hear gas solonoid ckick. Roper RGL4632BW (2 or Z) You have a thermal overtemp sensor that has failed, they are located in maybe two spots, but the diagram on the dryer ...

Termal overtemp LED light on, welder not working, not overheated Lincoln welder model Invertec V160-S machine lites up but the thermal overtemp LED light is on, the welder is not overheated ...

...the temperature light still comes on. The low water level sensor is in the overflow bottle, not the overtemp sensor. The overtemp sensor will be on the motor somewhere. To check you have the right ...

I FIND THE ERROR 010-320 WE CAN'T USE THE COPIER, BUT MACHINE IS WORKING That's a fuser overtemp fault, meaning your fuser either has a peice of paper jammed up in the fuser or the thermistor is blown

engine overtemp overtemp indicator came on ,put in garage to look at and went off overnite without doing any thig to it. Now its back again???? check coolant level

overtemp 'overtemp' code on the readout. What is the likely issue? The cooling fan is probably not working. Unit will overheat. Check the fan to see if it run continuously with no scraping noise with ...

...Charlie Transmission will go into a limp mode ( third gear only) when the computer sees and overtemp condition. Need to have the fluid checked and codes pulled. Overtemp usually means trouble ...

...HEATS UP THEN IS LOADED TEMP SEEMS TO FALL AND HAS TO BE RESET If you manually reset by pressing overtemp thermostat, then check your operating thermostat.. maybe over heating.. if so replace ...

I have an Optoma HD20 and when I turn it on the overtemp light goes on within 2 or 3 seconds....any idea's ??? When I power it up the overtemp LED comes on in a couple seconds....I never hear any fans