Questions & Answers for: Panasonic overheated microwave

It shut itself off after 7 min. Microwave.... I assumed it over heated but the microwave after 2 days now hasn't turned on. I was searching the forums and stuff, my thoughts are it could be the fuse ...

...overheated & fuse blown No power to microwave. Opened up and found the 18amp fuse blown...I replaced it and power was restored. Also found overheated/burned/melted wire connector on one of the door ...

microwave stopped working last night I unplugged the microwave and left it unplugged last night, plugged it back in today it started working then stopped again this afternoon? It is a panasonice 1300w

Overheating Panasonic NN-E225M Our Microwave a Panasonic NN-E225M has started to get very hot on the top when we use it. There are no other symptoms. Do we need to worry? i have seen tisquite a lot, ...

Have the new microwave for two months. Working very well, then on Saturday it melted the plastic lid on to the food. Now when you put in a microwave dish with lid it blows the lid off. Any ideas. ...

it will start for a few seconds then say h97 Sounds like your magnetron or inverter board. Is your microwave in a cavity? If the microwave doesn't have enough ventilation space around it then the ...

what does H97 code mean? Sounds like your magnetron or inverter board. Is your microwave in a cavity? If the microwave doesn't have enough ventilation space around it then the microwave is prone to ...

Microwave runs for about 3 seconds and turns off most likely the thermistor that shuts off the magnetron tube for overheating is defective,if all else is good and there are no hot odors,its mounted on

panasonic genius1300w cuts off after 3 seconds see this causes and fix it. God bless youDoor Switch If the microwave runs for a few seconds and then shuts off, a door switch might have failed ...

Panasonic NN-T945SFX microwave shut off after about 3 secs. @ 100% power level, but will run fine @ 70% power level. Overheating. I wonder if it has an internal cooling fan that has failed? It is ...