Question about Audio Players & Recorders
...preamp outputs i want to hook up yamaha mx460 for music only can i hook up through the tape monitor output yes, you can have output signal at tape monitor output terminal and can be hooked to any
Question about PM7200 2-Channel Amplifier
preamp with no subwoofer output connected to a 3 way B&K power amp. The power amp as a right, left and center inputs along with right, left and center outputs for speaker wire. Currently hooked up are
output in Right channel on my Adcom preamp GTP-450 I have tried evrthing but I'm not getting output out of my right channel from this preamp. This happened suddenling after years of use Hi... Have you
preamp output i have a kenwood vr 7070 THX select reciever with a 7.1 preamp output. my question is if i hook up the m-282 amp to that output for the 6th and 7th surround speakers will i have to get a
...preamp, as it's volume control would not affect the Tape Output, so the output would be at maximum volume. If your scheme involves an amp that has it's own volume and other controls, it would
Question about Lifestyle SA-3 2-Channel Amplifier
output is without the VCA. Most amps default to full ON and the preamp attentuates the signal with a volume control. Try it with a signal that fades in slowly so you can intervene if it gets too loud.
Question about Lifestyle SA-3 2-Channel Amplifier
...ok when you test them by regular meter. Check 1.2 kOm and 4.7ohm resistors at preamp pcb. Check diodes on output pcb (could be smd type, connected from base of output transistors to emitter i
...preamp because you have a magnetic (low output) cartridge. If you have a piezo type cartridge the output should be enough to drive the amplifier to rated output. Of your unit does not have a phono ...
Question about SA-DX930 Receiver
...preamp as the output is greater than a magnetic type. You should select an unused stereo (left & right) INPUT device such as "VID2" Connect the output of the preamp to these jacks and the ...
...output jacks on the preamp are functioning properly. Check the power supply: Make sure that the power supply is providing the correct voltage to the preamp. If none of these solutions work, it is ...
Usually answered in minutes!
6,442 Questions
5,455 Questions
4,073 Questions
2,449 Questions
2,268 Questions