...open the radiator cap when the truck is to hot ) 4) check the heater core to see if it is plugged. 5) If you have one of those flush kits installed on your heater hose remove it and make sure that it ...
...dashboard; open the driver's side door and look at the end of the dashboard; you will see the access plate, it will have a "thumb-hook" on it where you can pull it off with your fingers...the fuse ...
...dashboard on the right side. It is designed to open the fuel pump power circuit in the event of a collision. The switch is reset by pushing each of 2 buttons on the switch simultaneously (some models ...
to the bottom inlet and make sure you feel the vacuum from the upper port ,that way you know if its opening .My two wheel solenoid worked on 2x but my 4x solenoid did not work .Also found that voltage
...Open the passenger-side glove compartment box. Remove all of the items currently stored in the glove box Notice two screws on the inside ceiling of the glove box securing the glove box to the ...
...dashboard may be used to retrieve the stored codes. This method displays only the stored codes and does not allow for any system investigation. To activate the tests, use a jumper wire to connect the ...
...open" circuits. No electricity is flowing to the required accessory. If you live where these is no road salt, then it sounds like there may have been an accident with your truck that was improperly ...
Question about 1996 F150 Regular Cab
...Open the door, look at the side of the dashboard, pull cover off panel, flasher relay is marked as such.) However, there may be a more complicated problem that requires pulling the turn signal handle ...
Question about 2003 F150 Regular Cab
...which fuse I need to change A lot of cars have another relay box in the engine bay . Recommend opening this relay box and there is a good possibility you will find a fuse marked on the lid of ...
Usually answered in minutes!
2,636 Questions
1,214 Questions
1,298 Questions
1,160 Questions
1,038 Questions