...TO LCD TV VIA HDMI AGAIN. THE ONKYO DOES'NT DISPLAY ONTO THE TV UNLESS TURNED BACK TO STANDBY AGAIN THEN BACK ON AGAIN REPEATEDLY. indictor on amp only shows Ls and Rs. the sub and rear not ...
onkyo tx-sr500; power goes out; standby light blinks power goes out; standby light flashes Remove all Wires form speakers Power on Push Video1 + StandBy /On appears Clear on display
Onkyo system at the dealer ??. If its OK try resetting the system. Remember you will loose all your stored presets ( FM and customized settings ) and the Amp will go back to factory settings. While in
Question about TX-SR307 A/V Receiver
display. i try to repair but still c/n on >.< need to on loan board try repair My Onkyo AVR TX-SR307 turning off as i turn it on. I have checked all solutions like unplugged all speakers , reset
Question about TX-SR307 A/V Receiver
...onkyo tx-sv303pro without the remote rear speakers were turned to 00db n wont turn back up To reset the AV receiver to factory default ,turn it on and, while holding down the (VIDEO 1/VCR) button, ...
Question about TX-NR515 AV Receiver
Onkyo TX NR515 .. when in standby mode .. light is not coming on .. everything works fine .. i must have pressed something by mistake but cant work it out what ... on the display panel in standby mode
...onkyo HT-R395 Hi, please see procedure below. Resetting the main unit Use this procedure to reset all the receiver's settings to the factory default. Use the front panel controls to do this. 1 Switch ...
Question about TX-NR515 AV Receiver
...Onkyo USA. To reset the AV receiver to its factory defaults, turn it on and, while holding down the [VIDEO 1/VCR] button, press the [STANDBY/ON] button. "Clear" will appear on the display and the AV ...
Question about TX-NR515 AV Receiver
...ONKYO TX-SR6O3X RECIEVER Its By Itself Or The Owners Manual to Help me reset it Resetting the AV receiver to its factory defaults To reset the AV receiver to its factory defaults, turn it on and, ...
Question about TX-NR515 AV Receiver
Onkyo. The subwoofer out may be stuck off, even if the settings say its on. hold down the Video 1 and Power on/ Standby buttons. The display should say Clear, then enter standby turn it on and try the
Usually answered in minutes!
6,442 Questions
5,455 Questions
4,073 Questions
2,449 Questions
2,268 Questions