Questions & Answers for: oil tube

...oil filter tube baffle on a 1967 327 The only place I can think of there being a oil filter tube baffle is the suction screen on the oil pump pickup tube. This should be inside the oil pain, attached ...

Ad

Question about 4 Cycle Blower/Vac

1 Answer

oil out of that tube cause that tube sits alittle above the oil level.If your oil level is right on the line then I would run it for a bit then check the oil level. If the level is still good then you

Ad

...tube on oil pump with a new O-ring and hand-start two bolts. Install bolt retaining oil pump screen cover and tube to main bearing stud spacer finger-tight. Tighten oil pump screen cover and ...

...tube on the side of the oil pan This tube sounds like it is the oil drain tube. The valve maybe opened allowing oil to leak out. The valve maybe a black plastic knob that pushes in then turns to

oil in spark plug tubes. Replacing valve cover gaskets and spark plug tube seals at top of tubes. Concerned about bottom of tube. Is that an area that might also be leaking? Should I re-seat the tubes

Question about 2006 Sprinter

2 Answers

...oil feed tube That oil comes to turbo from engine block via turbo oil feed tube and also cools dawn the bearings and shaft It is an oil tube that supplies the turbo with much needed oil, under ...

...tube. Each one of thses tubes has a clear oil that the light shines through. Over time this oil gets cloudy and distorts the light thus dimming and fadeing your picture please have a tech change the ...

...tube for checking the oil level. to put the oil in the engine, there should be a oil cap on the right hand side valve cover. if the dipstick tube isn't there, you definitely need to get one from a ...

oil tube comes from the carb directly and goes into the oil tank to pressurize it, then the oil flows out of the tank and to the adjustable oil valve or if you bypass the adjustable oil valve it would

...Oil pickup tube bracket Radiator outlet pipe Upper oil pan and oil pickup tube installed Install a new O-ring to the lower crankcase. Apply a bead of silicone sealant to the upper oil pan flange. ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...