Questions & Answers for: GMC Jimmy oil spraying

...dirt or rust deposits in the ignition lock. I'm going to try cleaning the key hole with a light oil solvent, followed by some canned air to blow out the residue. Then a light coat of graphite ...

Need to change oil pan gasket in a 1998 GMC Jimmy 2 wheel dr 4.3 My question is, Do I need to remove the engine completely from the car in order to replace gasket? On many vehicles the exhaust runs ...

...vacuum leak at the intake manifold gaskets. This can easily be done with a can of WD-40. Spray the oil around the gasket areas, and, on all vacuum lines.P.S. do this with the engine running. I'm

...spraying a stream is open and the fuel pressure will never come up to what is required to start and run the engine. I would also look at the oil. If the injector is dumping fuel a lot of unburnt fuel ...

...oil out of the bottom and sprays gas all over the engine, just replaced fuel filter thought that was the problem turned out to make it worse-help! if its spraying gas you have a big problem is the ...

cant find the oil leak under a 95 jimmy any suggestions Go to your local high pressure spray wash and clean the engine. After it is dry place paper or cardboard under the car and run the engine. Find ...

engine wont start when wet spray 40d or a silicone oil replent around the electrics and this will drive out any water make the engine run ok.adrian.adrian,,,,,,

...valve and turn key on and off 3 times should be good enough, id check to make sure you have good oil pressure ,then make sure oil pressure switch isn't at ...

...switch it back by hand Sounds like it needs a bit of lurication. You can use a bit of penatrating oil (spray can with plastic tube) to looseein it

...like its disconnected in the front area...? The locking mechanism sounds faulty. Try spraying the pedal assembly with some penetrating oil to see if the racheting mechanism will start working