Questions & Answers for: Chrysler Town & Country oil spraying

Question about 2005 Town & Country

1 Answer

oil is'nt spraying out as the engine runs.Check the oil level.Possibly a vaccum hose was knocked off causing air to be sucked in (thats popular) which affect the idle & causes whining.Have you been to

Ad

Question about 1999 Town & Country

2 Answers

... try getting some lock lube from the hardware store, spray it into the lock, (never use any kind of oil just the graphite powder lock lube) spray the lock lube into the key cylinder and then work the ...

Ad

Question about 1999 Town & Country

1 Answer

belt. With the motor idling, lightly spray the serpentine belt as it's spinning with WD-40 or other oil based lubricant (Don't spray near the alternator). If this doesn't work, turn the mortor off and

Question about 1997 Town & Country

1 Answer

...brake can't release parking brake on 1997 Chrysler T & C Your cables are probably siezed--try spraying the cable where they go into the housing with penetrating oil like WD40 sometimes this

Question about 1998 Town & Country

1 Answer

...try spraying dry silicon lubricant from a can to the strut mounts and suspension bushings. Do not use oil or grease, oil base lubricant will eat away the rubber bushings. Good luck and keep me

2004 Lincoln town car 73,000 miles. Large black oily spot in driveway and heavy spray in driver side front wheel well - spray extends back on total side of car. Very very black liquid, smells kind of ...

Question about 2002 Town & Country

1 Answer

...driving, as there is not much to grip when the knob is in. Is this knob easily replaced? Might a strategically placed drop of oil solve the problem? Thanks for any advice! Try spraying it with

2001 chrysler tc pcv valve stopped up, replaced it ,now it start but dies started leaking oil between engine and trans,changed oiland air filersand pcv valve now will start but will not idle unless ...

...frame rain. Need line wrenches/adjustible or open end wrenches. Spray connections with penetrating oil and let sit prior to

...it is to drill and thread tap the broken part screw in a bolt with a lock nut tighten lock nut down on broken part then gently turn the bolt left and right keep spraying it with release oil GOOD

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...