oil sending unit where is the oil sending unit on my 2000 dodge durango? My oil pressure dropped to 0 - checked the oil and it was fine, no engine noise, nothing. Have been told it was my sending unit
...oil sending unit on a 1999 Dodge Intrepid? Location of oil sending unit on a 1999 Dodge Intrepid. Oil light stays on and I need to change this unit to see if that is the problem or the oil pump. ...
...oil pressure sending unit on 2004 dodge stratus? oil light comes on after the engine has been running for a while. Only comes on when I stop and the engine idles under 1000 rpm. There is no definite ...
oil pressure sending unit location where on a 1997 dodge stratus (2.5 v6) is oil pressure sending unit located? oil pressure sending unit show location on 2000 dodge caravan V-6
...oil sending unit fixed.what is that and what does it do for the car? Hi..my name is Keith..and the oil sending unit sends a signal to your oil pressure light or oil pressure gauge....i hope this has ...
...remove oil pressure sending unit and install a pressure gauge check for pressure while warm if pressure is ok replace oil pressure sending unit oil pressure at idle should be between 5-15 psi at ...
...oil sending unit and install a oil pressure gauge.You did not specify the motor so you can find it by the oil filter.remove the oil sending unit and install the gauge.Let the motor get to operating ...
Question about 2005 Grand Caravan
oil sending unit on 2005 dodge carvan The engine produces oil pressure from the resistance(clearance ) between the bearings and crankshaft and the sending unit lets you know when there is no pressure.
Question about 2005 Grand Caravan
...oil pressure sending unit located in a '01 dodge dakota, 4.7 eng.? with a 4.7 eng. oil all over top of eng. oil gauge shows low , check gauges light is on. go to CTC and buy a service manual for 2001 ...
Question about 2005 Grand Caravan
...quad cab 1500 in the dash where you can read it if you are mistakenly referring to an oil pressure sender unit, it will be near an oil filter housing or in the oil galley moulding along the block ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions