Questions & Answers for: oil pump 5 chevy

...change code. I need to know the procedure to reset the change oil on the odometer. Turn the ignition key to the run position and pump the accelerator 3 times within 5 seconds. Please leave

...Just had the oil changed. The CHANGE OIL LIGHT can be rest by putting on the key with engine off, and pumping the gas pedal up and down completely 3X in 5 seconds. Sould clear then, if nec.

...when you get to oil and % press on the checkmark and that would do the trick. Yes that is correct i own a 06 turn the key to run (Without Starting) And pump the gas petal 3 times and it should clear ...

...oil switch. that starts the pumps circuit when the key is turned on. after the engine builds up its normal oil pressure the computer shuts that oil switches circuit off and turns on the fuel pump ...

...pump operates off the oil pressure switch the first 5 seconds upon starting. to test turn the key to the on position and listen for the fuel pump running. it does this to prime the pressure up and to ...

...pump run for 5 seconds. if not heard replace the oil pressure switch for the third wire on that sensor runs the fuel pump the first 5 seconds to start the engine. once pressure is operating at normal ...

...HOLDS 5.0 QUARTS OF OIL WITH NEW FILTER AND CHEVY COBALT SS SC HOLDS 6.0 QUARTS WITH NEW FILTER.IF OIL LEVEL LOOK OKAY.CHECK ON INTERNET FOR ANY RECALLS OR ANY TROUBLE WITH EARLY OIL PUMP

oil pump replacement remove How to replace an oil pump on 5 cylinder 3.5L 2005 Chevy Colorado 4x4 Oil pump replacement is normally a huge just that involves removing the engine. Check out the YouTube ...

...oil pump, 0 pounds pressure, pickup tube good, o-ring installed correctly on pickup tube, checked with mechanical gauge at sensor still 0 pounds oil pressure. Any suggestions? remove the pump and the ...

How replace oil pump on the iron duke 2.5 Where is the oil pump in a 1988 2.5 L iron duke the s10 site for all people with chevy s10 with the 2 5 iron duke motor try this link