Questions & Answers for: oil pressure problems jeep cherokee

OIL PRESSURE SENDING UNIT ON MY JEEP CHEROKEE 1993 WHERE IS IT LOCATED AND IS THERE A DIAGRAM OR PICTURE LOCATION FOR IT OIL PRESSURE SENDING UNIT ON MY JEEP GRAND CHEROKEE LAREDO 1999 WHERE IS IT ...

oil pressure gage at zero when engine is running on my 1999 jeep grand cherokee v8. plenty of oil in engine if the engine is running normal and there are no odd sounds from engine. probably needs oil ...

...oil pressure when oil is full. done replaced sending unit and still have the same problem You need to verify the real oil pressure with a good oil pressure gauge. These are pretty simple gizmoes with ...

oil pressure on the gauge (had the oil switch? replace), put on a new ignition coil, and distributor. What seems to be my problem? If you have zero oil pressure thats a BAD sign, first have a mechanic

...oil pressure gauge to fluctuate on my 2004 Jeep Grand Cherokee Laredo? If the oil pressure is good and there is no engine noises then the oil pressure sending unit is the problem.Just replace it and ...

...oil pressure gauge drop Idles at 40 lbs pressure give it some rpm and it goes to 0 lbs. Pulled pan, screen is clean.Hooked up another gauge to block. Engine has good oil pressure. Sending unit was ...

...OIL PRESSURE SWITCH-I'm not sure if this is the gauge sender, though. 1995 Jeep Grand Cherokee 4WD 4.0L MFI 6cyl The Oil Pressure Switch is located: Under hood, passenger side, lower engine area, ...

oil pressure but wen i accelerate it goes to middle pressure but then down to low wen i stop wat can be the problem? Oil pump or other issues Cam bearings,etc Bad sending unit I would put a mechanical

oil pressure drops to 0 when sitting at a stop light but fine when i am driving Check the type of oil you are using as it clogs the pin in the oil poressure sender unit. It is your oil pressure sensor

...oil pressure for 2000 grand jeep cherokee larado its about 75 now. i want to buy this car but worried about the oil pressure. Normal oil pressure should be between 40 and 60 psi. A cold engine will ...