Questions & Answers for: Suzuki oil injection

...oil injection takes Use 10w40 motor oil in the gear box. Don't use any synthetic oils, oil marked "EC", or oil with "special" additives. Use Two Stroke ENGINE oil in the pump. Top rating?

...oil injection takes I recommend a motorcycle transmission oil as it has the proper additives for a wet clutch. I like yamaha's trans oil plus for my bikes.10w40 motor oil will do in a pinch. and I ...

...oil?? i dont have the manual It is not F1. It is Fuel Injection FI. The fuel injection computer chip is telling you it has detected a problem. You will need to visit a dealer to have them read the ...

...oil injection has been removed, low hours, hard to start, when we do get it running, it will not rev up, idles ok, but bogs bad when you try to accelerate. New plug, pre-mix in the tank, Compression ...

to use thanks alot :) which engine oil are you talking about. There is a tank under the seat that uses injection oil for a 2 stroke, or the engine oil in the crank cases that uses 10w40 motorcycle oil

...sounded like it was on a rev limiter (not enuff revs to move it tho) Two strokes are bad with fuel/oil mixure. If this is premix theres a problem,if injected you may not be getting oil injected. ...

...oil injection system to inject oil into the crankcase. We recommend plugging off the original oil injection system in favor of mixing the oil with the fuel on these older models unless you are sure ...

...gear oil! Can be 10w40 or 20w40 motorcycle grade.. UNDER the seat is 2 stroke injection oil. Personally I run yamalube 2s.. but any 2stroke oil designed for motorcycles and oil injection is ...

oil injection is failed and you are mixing now or it is a old RM? Please get back with that info and you will get a better answer. If oil to fuel is the question then 32 to 1 would be good for a newer

I just got a Suzuki DR Z1 10 kids dirtbike I want to know if it's oil injected or do I mix cannot find the reservoir for the oil Hi Rich: Here's a link to the ...