...oil outlet valve seat of fuel injection pump, too much tightening torque will cause the deformation of plunger sleeve, impurities entering into the clearance of plunger pair, too thin gasket on the ...
Question about Cool Tech 34700Z Recovery, Recycling, Recharging
...oil injection then you may need to check oil injection CHECK VALVE or oil injection SOLENOID ( Both located under Hidg side panel mountin valve). NOTE: UV Dye is not a problem for oil injection! I ...
...oil injection system to inject oil into the crankcase. We recommend plugging off the original oil injection system in favor of mixing the oil with the fuel on these older models unless you are sure ...
...gear oil! Can be 10w40 or 20w40 motorcycle grade.. UNDER the seat is 2 stroke injection oil. Personally I run yamalube 2s.. but any 2stroke oil designed for motorcycles and oil injection is ...
...type of oil do you use for a 1972 yamaha dt250 Two cycle engine injection oil - any quality two cycle injection oil.
Crankcase oil - Quality 10-w30.
A DT2 is a 250cc enduro - on/off
injection pump. 6. Oil Supply Problem - Oil transfer pump doesn't supply oil or the oil supply is brokenly. Solution: Check whether the oil inlet pipe is leaked or not and the filter screen on the oil
...is one suggestion, check the exact plug type, oil injection adding to much oil, (has it been changed) cheap 2 stroke injection oil, buy good oil. has anyone fiddled with the carbs, ar they Mikuni ...
oil injection is failed and you are mixing now or it is a old RM? Please get back with that info and you will get a better answer. If oil to fuel is the question then 32 to 1 would be good for a newer
Question about 34988 Premium AC Recover, Recycle and Recharge Machine
Robinair 34988 won't inject oil? We are injecting it on the high side, also we have 7 oz. of oil in the container but when it goes to inject it doesn't it doesn't even seem to try and when
Usually answered in minutes!
317 Questions
162 Questions
122 Questions
