Questions & Answers for: od fault

OD light is flashing to alert u to the fact that some kind of fault has occured in the transmission, the problem is in many cases a slipping condition, you need to have the trans control system tested

Ad

...OD light flashing means a fault has has been sensed by the transmission control module in the electronic transmission controls, to see what this fault might be have the transmission tested for ...

Ad

...fault. Enjoy your vacation. I have an '04 F150 and I had an OD problem that was the same as you are having now, I brought it to a deqaler they told me that I needed a new trans or a rebuilt ...

Question about 1998 Sephia

1 Answer

...OD light flashes it is to alert you to the fact a fault has been detected by the TCM (transmission control module), u now need a dealer to test the system for the fault code that is stored in the TCM ...

...OD light is now flashing. HelloThe Engine and Automatic Transmission (not applicable to manual transmissions) in this vehicles drive train are fully electronically controlled by a computer called the ...

Question about 2008 Rio

1 Answer

...my OD indicator light in my 2008 kia rio automatic will not turn off. have vechicle code scan see what transmission fault code you getting. could have faulty over drive switch or fault in the

...fault in the od section of the box. If the od band/clutch is slipping it will cause the oil to over heat. Have a pressure test done on the box to ensure proper operating pressure. Check for correct ...

Question about 2001 Ram 1500 Truck 2WD

1 Answer

...dodge ram 1500 quad cab 4X4 5.7 hemi, 45RFE transmission. slips in overdrive. shut od off and transmission works fine. any suggestions? run fault codes and look for TCM fault or OD servo/sensor

OD light is blinking because the transmission control module has detected a fault in the transmission operation, most common is slipping as measured by the input and output turbine shaft speed sensors

Question about 2005 Crown Victoria

2 Answers

...OD light flashes when a fault is detected in the computer controlled transmission, you need that fault code read with a scan tool. If the OD light is flashing there's a trouble code stored in the ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...