Questions & Answers for: Roland will not work

...not sure because the rest of my pads work. One will work if I hit it extremely hard but otherwise no. What can I do? Check the connections on the undersides of the pads--they sometimes get loose as ...

...parts inside, or send it to a service center. Try www.syntaur.com for a parts source. If one output jack does not work, but the other does, then it is most likely a problem with that one jack

...I use a battery the led works properly. Can you help me with my problem? Thanks Maxime Sorry, but this pedal takes a 9 VAC, not DC like many adapters. Pedal board power will not work with this

...same problem. All my flash cards worked fine, and all of the sudden, none work. Not even the one that came with it. I am still trying to fine the reason. I bought it eight years ago, that might be

Buttons not working The buttons of my Roland sp 606 is not working the hold button and 3 more buttons... What can I do? open the back panel and clean the dust and close then turn on the sp 606

...it's place on the keyboard. Plug back in and see if that worked. If this did not work, you may need to replace the keyboard OR you may want to make sure no viruses are playing an aweful trick on

...It was either the SPLIT function...with one of the volume sliders down, or MIDI channel. Sorry not much of a solution...hopefully this will jog your memory into experimenting with some of the ...

...work, however, the amplifier will not be properly grounded. So in a pinch you can use it, but you need to get the cable replaced. The ground wire is there for your safety, in case you plug your amp ...

My Engrave is not working. After I switch on, all i see is the leds brinking and no control key works after this https://www.youtube.com/watch?v=p2xugw_Qw-Q EGX 30A Out Of Box Setup 1 of 3

...It depends. If the USB drive is working properly, then the lack of a yellow indicator light may not be a problem. However, if the USB drive is not working properly, then the lack of a yellow ...