gas does not flow to the ignitor. Is there a procedure that has to be done before the ignitor heats and the gas flows? Thanks for your help. Tom If the ignitor is not powering , go to the switch. That
...not. On a gas dryer gas is flowing "TO" the gas valve all the time. It does not flow "PAST" the gas valve unless the gas valve opens and the burner is lit. This is based on other components working ...
...gas valve should not be opening unless the glow igniter glows and sends a signal to the gas valve. I suspect a small leak in either the gas pipe or at the gas valve. You will have to get to the gas ...
...gas does not always ignite I have a Kenmore gas dryer. The gas does not always ignite. When I open the front panel, I can see the glow light and then a few seconds later I hear a click. The gas then ...
Question about Minimax Ch 250,000 Btu Natural Gas Pool Heater Millivolt Ignition
...which is not natural gas. The gases behave a little differently, so the burners operate a little differently. Some are easily convertible, other not, but they are most definitely not
not. With the gas on I would carefully loosen union or flex fitting going to gas valve.If you have gas there then retighten union and go to fitting on pilot line and check it.You should be able to get
Question about 40 Gallon FVR NATGAS Water Heater 6 YR 22V40F1
...not open, and no gas will reach pilot once red button is released.Tip of thermocouple has to sit in the pilot flame.If pilot flame will stay on, then thermocouple is good.Problem is not solenoid ...
Question about Furnace Gas Valve Sv9501h2409
the gas Valve is not opening replace your gas valve If your not getting a full 24 volts check your Transformer and the ground to the gas valve.If the gas valve still does not open change the Gas valve
Question about 79012 / 79014 / 79019 Gas Kitchen Range
...not getting gas flow. Turn the gas off about 2 months ago for a remodel. Turned it back on and now the top burners and the oven are not getting any gas flow. Sparks are good, but not smelling any gas ...
Question about H Series Electronic Ignition 250,000 Btu Pool Heater H250ped2
...not open, gas valve is defective. Replace gas valve. 2. If 24VAC is not present, gas valve relay on control module is defective. Replace control module. 6. Check for blockages in gas orifices and ...
Usually answered in minutes!
1,743 Questions
1,329 Questions
1,410 Questions
1,123 Questions
940 Questions