not agitate. If it does not complete the cycle, then it can be a problem with the timer control, see The cycle doesn't advance . If cycle goes on, but does not agitate, it can be the agitator and more
Question about Nextra HNT 2135 Top Load Washer
...rubber nubs on a cylinder that fits over the agitator shaft. If the nubs wear down, the shaft will not turn properly or it will turn weakly. If the agitator is moving in only one direction, the ...
Question about U6630-900 WindTunnel Bagless Upright Vacuum
hoover wind tunnel 2 bagless vacuum not working have a hoover wind tunnel 2 bagless vacuum. it vacuums about 15 seconds after turning on and then starts a horrible sound. it appears to be okay when ...
Question about Runabout U50-940 Bagged Upright Vacuum
...effort may be required to stretch new belt onto pulley. Turn agitator, making sure the belt is not pinched between agitator and cleaner body. The belt must rotate freely inside the belt guide.
Question about WindTunnel 3 Pro Pet Bagless Upright
Hoover UH70935 windtunnel agitator spins like crazy with plate off after cleaning but will not with plate replaced.... what is going on? Removed bottom plate to clean agitator of my UH70935 hoover vac
...effort may be required to stretch new belt onto pulley. Turn agitator, making sure the belt is not pinched between agitator and cleaner body. The belt must rotate freely inside the belt guide.
Question about WindTunnel 3 Pro Pet Bagless Upright
...agitate the drive motor might be defective. This is not common. Check all of the other related parts to this symptom before replacing the motor. If the motor is visibly burned out or physically ...
Question about WindTunnel 3 Pro Pet Bagless Upright
Hoover 2300L 6.okg boss. Squeaking when agitating back& forth, not when spinning. Is this a bearing problem? & is it replacable. If so, from where in south australia? Or wherever.? Washing machines ...
Question about WindTunnel 3 Pro Pet Bagless Upright
...to help. Unfortunately, ime, the "goop" has always signified a transmission shaft seal failure and nothing less than replacing that seal will solve the problem most hovers nut down through the
Question about WindTunnel 3 Pro Pet Bagless Upright
Hoover 800 RL Agitator -bown no longer locked on spin. Just agitator spins. Has not been out of balance just prior, agitator works normally on wash. check belt if ok check under agitator for worn cogs
Usually answered in minutes!
116 Questions
99 Questions
66 Questions
56 Questions
46 Questions