Questions & Answers for: noise when turning

...noise when turning right Noise was loud, I found the Driver side outer Tie Rod was worn bad. I replaced both sides (driver and passenger) and re-aligned it. The noise was much less but still loud. ...

Hi, I have a Ssangyong 2007 Rexton 2 and since I bought it from new it has made a noise that can only be described as a clunk when I go around round abouts or turn right on sharp bens or turns; the ...

When I turn right there is a humming noise. When I turn the wheel left no sound. I'm trying to figure out what the noise is being caused by. Cv joints maybe? COULD BE TIRES NOISE OR WHEEL BEARING ...

When I turn on the air conditioning I get a noise, when I turn it off, the noise stops. It's gotten louder the last couple of days. Every once in a while when I turn on the car, there is a noise ...

2006 dodge stratus road noise i bought the car used from a dealer and it had a slight vibe as the vehicle rolls. I replaced breaks and rotors and tires. was ok for a time but has now gotten to be a ...

...noise when turning boxer van clunk on drivers side when turning slow One of the driving shafts cv bearing  worn out ,Drive in the park  turn left   not noise  turn right  you ...

hp laptop hp 430 What to do when a laptop makes a loud noise upon start up?I turned my laptop on today and after it showed the HP screen, it started making this loud noise, like a siren. I turned it ...

...noise when turning have the brakes checked in the front. if its a clicking noise only when turning to the right then you may have a bad cv joint on the right half shaft. replace the half shaft ...

noise when turning left when turning left I get this rattle noise, what could it be well it could be the brake pads rattling when turning have the brakes checked. it could also be a bad cv joint gone ...

...noise when turning(clicking type noise) or them hum at higher speeds. This also sounds like bearing noise. The way to tell the difference is bearing noise will get loader or softer when your are ...