Questions & Answers for: nm 85

...nm) Step 2 Additional 85-95 Degrees Step 3 Loosen 360 Degrees Step 4 28-31 (37-43 nm) Step 5 Additional 85-95 Degrees Step 6 Additional 85-95 Degrees Sequence: ...

...85 ft. lbs. (93-115 Nm). Outer tie rod ends. Tighten the nuts to 43-58 ft. lbs. (59-78 Nm). Sway bar links. Tighten nuts to 69-85 ft. lbs. (93-115 Nm). Hub retaining nuts. Tighten the hub nuts to ...

...to 85 ft. lbs. (115 Nm). Torque the castellated nut to 108 ft. lbs. (147 Nm). Upper ball joint specs: Tighten the mounting bolts to 42 ft. lbs. (57 Nm) and the castellated nut to 72 ft. lbs. (96

...Nm (20-24 Lb-Ft) Rotate 85-95 degrees Rotate an additional 85-95 degrees. Tighten in two steps: 20-30 Nm (15-22 Lb-Ft) 26-32 Nm (20-23 Lb-Ft) Advance 3/4 to 1 turn after gasket contacts sealing ...

toyota 3.0 d4d cylinder head torque 45 nm second stage 65 nm third stage 85 nm +90 degrees +90 degrees from genuine toyota 3.0 hilux d4d 1kd ft workshop manual

...for the lower ball joint arm need to know the torque settings for the lower ball joints arm Hi The following torque specs apply : 8 mm Bolt - 55 NM 10 mm Bolt - 85 NM 12 mm Bolt - 115 NM Regards ...

...Nm 4 Stage 3 Tighten to 85deg 5 Stage 4 Tighten to 85 deg 6 Stage 5 Tighten to 85 deg Sequence If it is the 01-08 model 2.8 CRD engine code R2816K4 then it is this one Stage 1 - Bolts 1 -18 = 30 ...

...Nm (28-31 ft. lbs) Rotate bolts 85-95 degrees Loosen bolts a minimum of one full turn Tighten bolts 37-43 Nm (28-31 ft. lbs) Rotate bolts 85-95 degrees. Rotate bolts an additional 85-95 degrees. ...

I need big ends and mains torque settings for ford sierra 2l 2ltr petrol engine, mains stage1 44 to 51 nm stage 2 85 to102 nm big ends stage 1 20 to 23 nm stage 2 40 to 47 nm

...85 Nm Connecting rod bolts: 55-60 Nm Main bearing bolts: 80-85 Nm Flywheel bolts: 65-70 Nm Oil pump bolts: 15-20 Nm Oil pan bolts: 10-15 Nm Oil cooler bolts: 10-15 Nm Note: These torque settings are ...