Questions & Answers for: nissan sentra crank

...NISSAN SENTRA 2.5LT. STARTS GOOD AND RUNS GOOD BUT GOT CODE P0335. WHAT SHOULD I LOOK FOR??? DO YOU HAVE ANY TROUBLE SHOOTING STEP??? AND WHERE IS THE CRANK SENSOR LOCATED AT???? THANK YOU crank ...

Ad

Question about 2003 Sentra

1 Answer

Nissan Sentra Loses Power My 2002 Nissan Sentra GXE (standard trans) used to run fine but now it idles rough and will randomly lose power when driving for no obvious reason. It will usually restart in

Ad

Question about 2001 Sentra

1 Answer

...know where the crank position sensor is on my 2001 nissan sentra Follow your plug wires to coil pack and module. Once you found the module, follow the wires from there to crank sensor on engine

Question about 2002 Sentra

1 Answer

...nissan sentra in disrepair 2002 nissan sentra, shut off at traffic light and will crank but will not start. changed out both crank and camshaft sensors but still no luck. There is no spark to the ...

...nissan sentra turn,s over but want start. no fire to spark plugg. The crank sensor may be at fault. sound like a crank sensor but it could also be a cam sensor. Same thing happen to me on my sentra ...

...Nissan Sentra cranks but wont start. Put a 2001 Nissan Sentra GXE cranks but wont start. Put a new fuel pump in it and the pump wont turn on. What could be the problem? good day Sir, try to check the ...

Question about 2004 Sentra

1 Answer

...nissan senta is having trouble when i start it it struggles to idle and will shut off. when i give it gas it just coughs and wont increase rpm my mechanic could not figure it out any suggestions? my ...

Nissan sentra 200SX cranks over but won't start Nissan sentra 200SX cranks over but won't start check fuel pump, fuel pump fuse, distributor,and ignition coil please. then you will need to check ...

...Nissan Sentra starting problem I have 2006 Nissan Sentra 1.8L and it is hard to start. I start it but after I turn it off I have to wait for a while to start it again replace the crank shaft position ...

...nissan sentra 1.8s no start, engine cranks, 5 speed will start by rolling and dumping the clutch. new cam, crank sensors, rpm on scan tool and it reads engine in cranking state while cranking. no ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...