Questions & Answers for: Pentair new pol

...then shuts off again..I'm now getting the E04 Message...Everyone I talk to is trying to sell me a new heater, when this one is only 4 years old...Please Help!! Your EO4 message tells you you have a ...

...NT heater that just started leaking water. Is it worth it to repair it, or should I just buy a new one? Buy a new one. I spent $650 beginning of season to replace the manifold that was leaking ...

...NT Heater Model 300 DV does not ignite after replacing the ignition controller PN 472447 and new ignitor P/N 472604. Worked with P/N 471602 Ignitor, but not after replacing. The ignition

...when you turn it on it runs, but after a couple minutes it starts smoking. Wiring is 110 which has new heavier wiring running from breaker box and a new breaker. What could be causing this problem ...

...pol is 160 degrees. So I am unable to heat the spa or the pool, as the heater will not come on. Also, on my main panel on the heater itself, the "LED" (I know that the lights are not LED) ...

Pentair MasterTemp 250 Natural Gas with "Service System" I have a brand new MasterTemp 250 natural gas heater. Had everything hooked up and the unit has a red LED "sytem error" on. Called the pool ...

Where can I find helpful instructions for replacing (removing old and installing new) thermocouple on Pentair 250k minimax ch NG mv? Thank you. I need instructions on how to remove the old ...

...but now the pump is getting air in it. Is there a way to test it all? The pool store is saying a new pump! UGH if you remember back i'll bet you had a little difficulty getting the old filter off ...

I installed a brand new pentair booster pump today. It worked fine for an hour, then started making a loud noise and leaking from by the shaft... Any suggestions? Thank you The pump may be defective ...

Pentair legend II pool cleaner, Brand new. The swivels on the feeder hose leak water profusely, i can't get a response from Pentair at all. Pitiful service. From your description that is bad ...