Questions & Answers for: Ruud new hose leaking faucet connection

...leaking hose from the vent to the pressure sensor, cold stacking in the flu(either a down draft or extremely cold air in vent that restricts warm combustion air from being pushed out), a problem with ...

...hose and drain to sump? Leaking water? Check the condensate hose for a blockage. If the condensate hose is missing, put a hose going to the sump. Make a small loop in the hose lower than the blower ...

This is our second Ruud, bought in 2006. It is This is our second Ruud, bought in 2006. It is has always been somewhat noisy but now it sounds like a muffled motor boat. We have had it checked out and

...new element. 9. Connect the wires and fill the tank. Check to make sure it doesn't leak before you turn it on. 10. Being careful to not touch the live wires, turn the unit on and allow it to heat up ...

hose to the tank drain with the other end emptying into into your basement drain or to outside of the house. Open the tank drain valve slowly and allow it to drain completely. Once it has drained, use

...leaking from the evaporator coil then you will need to replace the evaporater. As far as brand for replacement I like rheem equipment. The best thing to do is have a hvac technician come out and give ...

...leaking water. I see the post about clearing the drain pipe. But where is the drain pipe? find the indoor fan unit and there you will find a drain pipe or hose IF you can access the coil area then yu ...

carrier fk4dnf005- what are my options for 7 years old unit if leaks in Coil...to replace or got for new system ? i would go with a new coil you should get another 10 years on system.

higher inducer open error code flashing Pressure switch not pulling in. Pull the hose off the inducer motor to the pressure switch. Make sure barb fittings and hose are clear. Re-connect & run ...

I have a Ruud ugph-07eauer furnace. When it starts up the draft fan will run for a few seconds then shut down, and the OK light will blink 4 times, which means the pressure switch is closed. Help. ...