Questions & Answers for: KitchenAid new hose leaking faucet connection

...new filter, took icemaker unit out and thawed and cleaned, reinstalled, but problem is before the ice leaves the main unit. Your water hose that connects to the back of the freezer may be loose. Move ...

...new clamp. If that doesn't work, replace the hose. I Have Kenmore Elite that is leaking at the bottom of the door after it starts the wash cylce. Could this be from it overfilling and could this be ...

...leaking from bottom, front. Checked hoses at faucet and washer, all tight no leaks there. Seem to be coming from under the front lower lip of washer. it's the pump. release the control panel and flip ...

water connection from the wall water faucet to the fridge. Can you tell me the part number so I could buy this part? Thanks. You should be able to buy a generic water hose at your local hardware store

the leak appears at a connection, try a new clamp. If that doesn't work, replace the hose. Let me know, if needed further assistance. Hope i helped you. Thanks for using ' Fixya ' and have a nice day!

...hose connection. Remove the lower front panel, and check the hoses. The pump seal may be defective, too; replacing this is a job for an appliance repairperson. An older dishwasher may corrode at the ...

drain problem after the complete cycle is finished water remain in the bottom of the appliance Hi, The drain hose can cause the dishwasher to fail to drain properly. The recirculation hose can be ...

be from a leaking hose or loose hose connection. Check these by removing the bottom front panel. The pump seal may need to be replaced. If you are not real handy, call a repairman for this replacement

...new ones. Make sure the hose is still intact underneath the old clamp. If not, remove the internal hose and take it to an appliance repair center to find the correct replacement part. Good luck and ...

...leaking. if it is, it will have to be replaced. Look at the feed hose to the dishwasher and see if it is brittle and cracked, if it is, replace it.Look at the discharge hose for brittleness and ...