Questions & Answers for: Briggs & Stratton new hose leaking faucet connection

...hose from house to pump. water leaks at gun handle- took it apart and oiled piston- was ''grabby'' but now snappy but still leaks. Engine starts fine and runs fine. Please help. A leaking gun will ...

...leaking from the hose that comes out of valve cover the hose goes to the fuel pump ,oil leaks from it and drips onto exhast then the engine wants to die.i have'nt replaced the seal where the hose ...

leaking at point of connection between tip and wand Briggs and Stratton 2200psi and gpm 4.5 hp pressure washer I changed tips (it was working fine) pulled the trigger and the new tip flew off. I put ...

...ARE TRICKY, TO OPERATED YOU NEED TO OPEN THE WATER FAUCET CONECTED BY A HOSE TO THE POWER WASHER , OPEN THE TRIGGER AND THEN START THE POWER WASHER, OTHER WISE YOU WILL RUIN THE POWER WASHER

...use a new rubber washer to make a good seal on the supply hose on both ends. if either end leaks or can **** air, just a little bit of air into the pressure washer will cause it to loose

...or at least seemed new as the hose and tips were still factory wrapped. Any ideas? either there is compression from cylinder getting into crankcase pushing the oil out or the oil level is too

...hose. However, when the trigger is pulled, no extra pressure is provided and the engine does not make the sound that it normally would when under load. Sounds like your pressure pump is shot. Replace ...

leaking gas directly from primer make sure hose is connected and not cracked or broken

Leaks gasoline from engine Check the fuel hoses to make sure that they are not dry rotted and leaking fuel. Check to make sure that the fuel is not leaking from the bottom of the carb at the float ...

...new hose and filter, fresh oil. What next? This is a gravity feed system without fuel pump (Nikki carb) check the point where the fuel hose goes to the fuel tank there is very fine filter in the hose ...