...new spark plug, pour about a half teaspoon of gas in the spark plug hole, install plug and try to start as normal. He may have had old gas that is still in the fuel system. Please rate this solution ...
Question about Craftsman 36cc, 16 In. Gas Chain Saw
...new one. while he was out i also had to replace some fuel supply line and fired it up. it went straight to full power without me squeezing the trigger. this is too dangerous and i need info on how to ...
Question about "Chain Saw - 16" Bar, 3 Hp
...new kit. Just practice your patience on it! Oh and flush the gas for fresh one before use, maybe replace the sparkplug! lots of good advice,but what was not mentioned was to check fuel line from carb ...
Question about , No.455 Rancher, 20" Gas - Powered Chainsaw
55 leaks gas from cap just installed new one still leaks most cahin saws have a plastick tank witch splits under presher,, its most likely the tank leaking but it may be a fule line if you lucky
...gas, but it was still 3/4 full. so i checked for spark, has spark, tested the on/off switch, installed a new plug, performed a coil test via the old spark plug bending the gap extra wide and pulling ...
...new plug and change gas and clean carb Check the fuel filter, air cleaner, and muffler for plugging. Check the condition of all fuel lines. Make sure your 50:1 fuel mix is fresh and thoroughly shaken ...
new plug in and won't start run if you put a small amount of gas in plugfor just a second or so made sure gas line is not stopped up from tank to carb. less than 2 yrs old. seems to be firing but, won
...gas tank. the trick is to cut the new fuel line ends at an angle so you can insert into the fuel tank and catch the end inside the tank with needle nose pliars and pull into the tank , then cut ...
Question about Craftsman 36cc, 16 In. Gas Chain Saw
...fuel line can be retreived and install the new filter on the line, slowly pull the fuel filter back into the fuel tank,leaving some slack in the line to not kink the line.Please take time to rate ...
Question about Craftsman 36cc, 16 In. Gas Chain Saw
new carb on it and.now I can't get the primer bulb to prime gas what gives? https://www.partstree.com/models/440-e-husqvarna-chainsaw-2008-05/ The link shows components of the saw. Three fuel lines...
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions