Questions & Answers for: new axle

axle with new cv joints than to rebuild them. It is a very simple job in todays cars, remove tires remove lower tie rod , remove nut in center of the rotor and pull wheel assembley to the side hanging

...new axle. The axle keeps pulling away from the wheel hub pushing the snap ring on the outer portion of the shaft out of its groove. I've tried 2 new axles and they both did the same thing. The snap ...

...yourself push an axle in from wheel side and remove c-clip slide axle out pry out old seal replace new slide axle in careful of seal replace c-clip do on other side replace pinion shaft and bolt ...

...puller remove bearing, lubricate new bearing and install using new seal, examine axle for damage to bearing contact surface is good install , reverse procedure to finnish and fill rear end with new ...

...new bearing on. to remove the axle: place car on a level surface, block front and rear of the front wheels. jack up the side that needs the new bearing and proceed to remove the wheel. remove the ...

new rear axle 2002 durango This rear end replacement has been a nightmare. Got the new axle in and just need to put the rear drum brakes on but the shoes from the old axle do not seem to match up with

(new axle) will not lock into transmission.There is a ring on the end of the axle of shaft. Put both old axle and new axle on floor for review and they both look the same. Did you grease the snap ring

new axles will only go in and lack about 1Inch going in all the way? Do the axles have a metal ring called a circlip in a groove of the axle, about an inch or two from the end? If they do, you have to

...new position will remain ON constantly. If there are problems with electronic part of the systems the shift control switch light will flash warning of a problem , If no lights you have a mechanical ...

How to replace rear axle bearing? Buy new axle bearing. Remove old axle bearing. Install new axle bearing.