...need to know how to wind the bobbin. Do I put the thread into both the top and bottom hole of bobbin to wind? I can wind the bobbin but the thread is loose and bunches up. just wind the thread around ...
Question about LS-1217 Mechanical Sewing Machine
...bobbin. In order to get mine to wind i had to lett the tread go down and then slip the thread in the groove. also remember to leave the pressure foot up do not put it down. let me know if this
Question about Featherweight 132Q Mechanical Sewing Machine
...bobbin is about 3/4's full each time, you probably don't need to worry about it if all else is good (even tension, consistent stitch quality, and so on). If you'd like me to post some general ...
...wind the bobbin tightly. sometimes with older machines you need to add a little tension on the thread your winding from with your finger. It sounds like its coming off the spool too fast to keep up ...
...wind around the metal button in a figure-of-eight type manner - go to right of button, around bottom of button, up the left side and over to the next guide at the bobbin winding area. I also have ...
wind the bobbin, you need to pull out the flywheel on your model to disengage the clutch for bobbin winding. Take thread from thread spool across to bobbin winder thread guide, then back to bobbin and
...wind pin needs to be adjusted to allow the bobbin to fill completely. Be careful if you try to do this yourself as there is a nut inside the machine backing the screw. If you loosed the screw to far, ...
...wind then the sensor underneath may need attention by you local technician. Do not attempt to open your Viking 1 as it may cause extensive damage and.will also null all warranties Let me know how you ...
Question about Viking 1
...Verify that you are threading it properly for bobbin winding. Perhaps the bobbin winder height needs to be adjusted. If you continue to have problems (which I frequently have with some of my ...
Question about Viking 1
wind and then take off again, make sure when you do that the bobbin holder clicks back into the sewing position not the winding, you might need to give it a little push in the right direction then see
Usually answered in minutes!
760 Questions
764 Questions
564 Questions
565 Questions
372 Questions