Questions & Answers for: Cisco Catalyst need switch

...I power on i have only this : "Switch :" That is the expected behavior of the switch. If you want to go into privilege mode, you need to type "enable" at that prompt and enter the correct

...switch, we need to have a console cable connected in the console port and an image for 3560 on your system, Issue the command " copy xmodem: flash: " after this go to transfer file in the menu of ...

...need to console into the switch using hyperterminal or teraterm and follow these instructions located at: ...

Need to locate PC's on our network, accurate to the switch port. Our network is a mix of CDP compatible switches and unmanaged switches that do not support CDP. Is there any way to determine what port

...tests to see exactly what component is failing. If this device is under SmartNET contract with Cisco, contact them for replacement. If not, you will most likely need to purchase a replacement

...the switch (5)When you are asked whether to configure or not, select NO. (6)The password is not needed when you log in from privileged mode to user mode. (7)Restore the configuration file renamed ...

...switch as a VLAN or do it as a uplink port? The cable modem will need to go through a router because it needs a NAT and PAT translation table, connecting the cable modem direct would lose the ability ...

Do I need to buy a software license for WS-C2960S-48FPS-L? If I want to buy a WS-C2960S-48FPS-L Cisco Catalyst 2960 Switches, do I need to buy a software license for it? No. WS C2960S 48FPS uses the ...

...2960 series switches support stacWhat specific models support stacking? If it support stacking,do I need to increase the stacking module? Or there is a stack port on the device? king? Yes they do ...