...need a wiring diagram for the wiper motor of my 1995 Ford Thunderbird. If that doesn't exist, a verbal description of what are the 6 wires going in would also help. Thank you so much! If the same as ...
...need a new switch? (could this be the cause of low pressure in the fuel rail???) with that switch tripped and you turn car over there will be very little to no fuel pressure in the rail. after ...
...the fan. it will come on with the a/c but not when hot I just don't know where the switchs are You need to replace the temperature control switch. It will be located close to the thermostat
...switch before attempting to disconnect the wiring connectors. The top piece on column does not need to be removed. Tilt steering stick should be removed. About a 4 or 5 mm wrench, smaller than a ...
...it is doing the same thing. what is the problem? The lock cylinder where the key goes in, does not affect your isssue. The ignition switch with the electrical connections is what you need to
later.. when I tried to start it ..the ignition stuck and made a very loud noise then the car wouldn't start. thanks IF SWITCH GETTING STUCK MORE LIKELY IGNITION SWITCH KEYLOCK CYLINDER NEED REPLACING
...switch first, it may just need adjusted sometimes they get kicked around. if not replace. a bad fuse and u would have no lights. if its wiring try to wiggle and see if u can get light to work with ...
...need replacing. If no power, work back to the neutral safety switch. Pull the connector off and check for a power signal to the connector with the key held in start. If no power, it may be the ...
need a flat head screwdriver to remove the light cover and the door lock and window switch. and a phillips head screwdriver to remove the two screws, the one under the door/window switch could also be
...safety switch wiring would be found in the wiring to the Transmission Range sensor, which also needs
Usually answered in minutes!
523 Questions
505 Questions
431 Questions
394 Questions
202 Questions