Questions & Answers for: Kenmore HE2 nail through a wire what should i do

Question about HE2 Plus Front Load Washer

2 Answers

nail shaft sticking out. Put the loop of one side of the wire, not the spring, and stretch the spring and put the other loop over the second spring. The loop is now big enough to fit over the boot lip

Ad

Question about HE2 Plus Front Load Washer

2 Answers

nail shaft sticking out. Put the loop of one side of the wire, not the spring, and stretch the spring and put the other loop over the second spring. The loop is now big enough to fit over the boot lip

Ad

Question about HE2 Plus Front Load Washer

1 Answer

Loses power in spin cycle I replaced my pressure switch and I ran a wash with no clothes.Washer worked great. Put my first load of clothes in and its running great.(here's my problem) In the spin ...

Question about HE2 Plus Front Load Washer

2 Answers

I have an F 24 error flashing. It is on the rinse spin cycle The "F24" error code is an indication of a water temperature sensor error. There is a chance that there is a loose wire connection on the ...

Question about HE2 Plus Front Load Washer

1 Answer

the water does not go down after cycle is done. kenmore 417-43042200 remove the lower toe kick panel below the door and remove the clean out trap,its a 2 to 3 inch round plug and it unscrews and it is

Question about HE2 Plus Front Load Washer

1 Answer

...it down? This washer should make very little noise in spin. Check if there is something, like a nail, stuck in one of the holes in the spin basket. What does happen with these machines is that

I fixed the control panel board and mixed up the wiring order please send a picture of what wire goes where? Model 11045862400 part num. 8182687 is what the wires connect to It is best to check this ...

Question about HE2t 3.7 cu. ft. Front Load Washing machine

1 Answer

Kenmore he2t F25 error. Trying to ohm test the MCU. Are you supposed to stick the leads of the multimeter into the holes of the white connector where the wires go in, or to the wires themselves? ...

...to check every single hole in the basket/ perforated drum to make sure there isn't a screw or a nail in the hole but not through. If the noise stops at speed then it is still in or on the drum as ...

Question about HE2 Plus Front Load Washer

1 Answer

drum clicking when the drum rotates clicks bad Something small like nail , Bobby pin , more than likely it will be too big to fall all the way through the drum but you need to find it before it causes

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...