Questions & Answers for: Hitachi nail gun

Question about EC12 Portable Electric 2hp Air Compressor, Oil Lubricated

1 Answer

...time using a Hitachi ec 12 4 gallon compressor? I think you'll have to look at your specs on your nail guns and see what the demand is . Whether measured in cfpm or psi, your compressor will tell ...

Ad

Question about NV45AB2 Roofing Coil Nailer

2 Answers

...nail gun will jam if it isn't properly oiled before using. Occasional oiling while doing a big job is a requirement also. I don't depend on an oiler in the air compressor line. I add oil before I ...

Ad

Question about NR83AA3 3 1/4" Clipped Head Framing Nailer

1 Answer

Nail gun jambs nais getstuck between driver and the tube where the nail exits the gun could be you have a piece of a nail stuck in the nose assembly, the driver is worn and make sure that you are ...

Question about NR83AA3 3 1/4" Clipped Head Framing Nailer

2 Answers

nail gun nr90ad leaks from trigger when air hose is connected Orings, they have to be replaced every few years. Warranty does not cover them. Any Hitachi service centre should stock them. Or find your

Question about 3 - 1/2" Full Roundhead Framing Nailer

1 Answer

...gun so its very unsafe. I want it to onlyshoot ONE nail at a time. How can I repair this problem. Thanks, Fritz Most all nail guns can be converted to single fire, however, usually parts must be ...

Question about 3 - 1/2" Full Roundhead Framing Nailer

1 Answer

...nail gun,piston/nail push rod wont retract after pushing nail (stays protruding out of gun so the remaining nails stay underneath it You have one or more worn o-rings in the head of the gun. They ...

Question about 3 - 1/2" Full Roundhead Framing Nailer

1 Answer

...nail gun will only shoot one nail, then the driver will not retract and is really a little hard to push back in. It is a hitachi framing gun. it could be you are using the wrong nails, the gun should ...

Question about NV45AB2 78Inch to 134Inch Roofing Nailer

1 Answer

nail. Gun is new maybe 15 lbs of nails or so. If the nail will not advance, easy test will determine problem. Open door and remove the nails. Lightly tap the nose of the gun against coiled rubber hose

...nail gun won't set nails into 3/4 trim. I have played with the turn/screw set adjustment and it is set for the deepest setting. This gun was purchased second hand off e-bay but my Hitachi nv65ah ...

Question about KNR90AE Round Head Framing Combo Kit With Compressor, Nail Gun and Hose

1 Answer

...a Rigid brad nailer and never looked at the Hitachi again. :) Sometimes you just get a lemon! (PS I understand you have a framing nail gun. Brad nail gun above is used for an example) Hope this ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Hitachi Air Tool and Compressor Experts

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Ngoro

Level 3 Expert

3521 Answers

john h

Level 3 Expert

29494 Answers

Are you a Hitachi Air Tool and Compressor Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...