Questions & Answers for: Whirlpool duet multiple error codes

...error. Door Lock Mechanism broken or removed from the Door Check Door Lock/Switch Assembly Check the wire harness connections to the Door Lock/Switch Assembly and Central Control Unit (CCU) Door ...

error coe for some time now, multiple techs have checked it. once they changed the entire drum assembly because of a broken shock, i recently replaced the belt and the mcu as advised by the tech but i

...multiple causes to the error code. So, check all possiblities. However, before you go through all of this, unplug the washer for AT LEAST 30 minutes to reset the Central Control Unit (CCU). This is ...

...error_code_whirlpool_duet_kenmore Unfortunately, this is a fault code that can have multiple causes. I would recommend you start by UNPLUGGING the unit for at least 30 minutes in an attempt to reset ...

...error was stemming from the CCU board. Order a new one at over $300.00 and have the same thing happen again - I don't think so. We tried EVERYTHING suggested on multiple websites.....unplugging the ...

multiple error codes. To answer your question, "yes", the CCU is something you can replace yourself and avoid the added cost of labor. The CCU, however, is generally not an cheap part. I have included

error message F5 about 3 minutes into the cycle, have to reset multiple times to override F-5 Water temp sensor failure If during the water heating step in the wash cycle, the water temperature sensor

...error. I've done just about everything I can think of to fix this. It started out a couple weeks ago, and the lady of the house just hit cancel and start and the cycle finished. Then it started ...

...multiple settings, and even let it go all the way down. Again, it stops at 1 minute, and never finishes. You have to press pause/cancel and wait for the door to unlock. I ran a diagnostic test, and ...

...not working. IS there a reset? F15 is a motor control unit error, this can be caused by a module failure or loose wiring or multiple error codes in a cycle, try un plugging for ten minutes to