...blow the fuse as soon as you apply power. hi i have the MTX thunder 7801 and it doesnt do anything everything is connected as the manual says but i get a red light with service only what can that
MTX Thunder TA81001 amp when truck is running and radio is on, voltage is ok, but when i turn the amp on, lights dim one to two seconds, and no other problems util the power is turned off, this is ...
...mtx thunder 300xd car amplifier "is the got two wires in the ground and remote turn on wie" Can you be more specific about the wiring...where the two wires are connected to and where they come from, ...
mtx thunder 4004 when powered up light turns on for about 2 seconds then turns off and wont come back on until power is removed then hooked back up. check for shorted output transistors
Apx stopped working, MTX 702x Amp stopped working, now has the power light going from a solid red to blinking fast, then solid.... maybe the audio amplifiers Ic´s damaged or the power fet
Question about Thunder 6500D Car Audio Amplifier
...fuse it is a mtx thunder 6500 d running a 10 inch thunder 5500 any advise? Sorry to say mate but that is one blown up amp! :( My solution to this would be to get another amp Sorry Matey Upfront ...
Question about Thunder 2-Channel Amplifier 502 Car Audio Amplifier
...MTX thunder 502x was working fine and know the amp light is flashing yellow and red. i have checked the fuses and disconnected the power and ground and reconnect, same problem. it continues even when ...
Question about X Thunder 1000XD Car Amp
mtx 1000xd led light is flashing and the subs will not work i have testes the subs and they work fine but the amp wont power them The light flashing usually means there is a short somewhere. Check ...
Question about Thunder 421D Car Audio Amplifier
...subs mounted in power wedge enclosure hooked up to a MTX thunder 4300x amp. One sub speaker has no sound and the amp has a red light that is always on? the amp is under to much pressure get a bigger ...
...mtx 251d thunder and still no light i check my connection is ok , if i do jumper it with the antenna and main power the light is on, i,m getting frustrated My guess is a short in your 12 volt remote ...
Usually answered in minutes!
55 Questions
42 Questions
24 Questions
26 Questions