...move the tonearm from the rest post over to the record and the platter will start turning. There is a small microswitch inside either below the arm base or near. There should be a flat bar connected ...
...arm can move fully into place, the record stops spinning and the arm moves back into the resting place. I have tried manually turning the record, and when i do this the arm moves into place and ...
...rest. It stops just short and then decends down onto the base. Is there an adjustment to make the arm go back a futher 0.5 cm? Yes there should be an adjustment at the base of the arm to use a ...
...turntable. To start lift tone arm off rest and move into position at start of record. It will automatically lift and return to rest as well as shut off at end of record. cheers john ,, ...
...the slidder control to make it work,don`t slide the control all the way.Just til you hear a click and then move the arm you`r self.Also make sure it is set to the size record you are trying to
...I have a radio cd player with CR24 turntable Move the tone arm off the rest on to the record and it will start to spin. There is a switch that turns the player off when the tone arm is on the
Question about PS-LX250H Turntable
...move the arm to about half way through the rocord the table spins again. Also the arm doesn't rest properly in its cradle. Any suggestions? Hi Daniel, its a bit of a long shot however try this. ...
...and sensible "head" Check the auto trip lever which should return the arm back to it's rest after the end of the record.It has possibly been advanced.Is this a belt frive or direct drive
Question about PS-LX250H Turntable
...sale purchase but it is in the original packing and appears mint. Hi, The auto reject/auto return lever has been advanced therebt tripping the arm to return to the pick up rest.It needs
Question about PS-LX250H Turntable
...move one bit . The power works but that about it . Where how to fix this The turntable needs to be turning. If it is not a manual turntable. , all arm motion is controlled by the spinning plater,. At ...
Usually answered in minutes!
6,442 Questions
5,455 Questions
4,073 Questions
2,449 Questions
2,268 Questions