Questions & Answers for: Yamaha mixer device

I use the Musicsoft downloader it says it cannot find the device during the connection check. try using stereo cables (RCA)....thats what i used before i went to 1/4 cables after adding a studio mixer

hiss as soon as i turned on the device to do a recording, found a high level of hiss. If trim controls or gains are set near maximum, HISS is normal as electronics generates a thermal type noise. If ...

...mixer and 10 aux (all 1 - 10) no work. Check that you have the gains INTO the aux channel from each strip you want routed there turned up... AND... the gains OUT of the aux turned up. Two places to ...

...to the external amp or powered speakers and power those from the SAME receptacle source as this mixer and any pwered devices connected to it for safety of the

...device called crossover which would divide the output from mixer into low-frequency signal and high-frequency signal which you would then connect to the front and rear analog inputs. But with RX-V365 ...

I am using this with Cubase AI 4 and my output is too low and if i try and turn it up, i get too much background noise. What am I doing wrong? Also when i listen while recording it sounds low but find

...the usb audio Make sure that in the control panel of Windows, "Sounds and Devices" under the "voice and recording" tab, the Yamaha mixer is shown as the device for both voice recording and

...mixer onto the Yamaha CDR-HD1300 CD Player / Hard-Disk Recorder? -- i.e Can I record a live DJ set straight onto CD? And/or can I record a live set onto the hard drive and then burn from the hard ...

...mixer is important to balance.  You don't give us a clue as to what music you are talking about... if it is from a device plugged into the tape inputs for instance, the fault is your source ...

...with Garage Band? If so, how do I get Garage Band to recognize my mixer? Using USB currently. what are you trying to do exactly? Garageband should recognize the mixer as a MIDI device