Questions & Answers for: mitsubishi tv red status light

...tv shuts off and status light turns on. Help if the "status" light is blinking red than you most likely have a fan failure going on inside the set. there are 5 fans in the tv and it could be any one ...

...TV worked fine after words. A steady red light: there is a short on the DVI cable from FMT to DMD disconnected Mitsubishi V26 error code 41 with solid red status indicator is caused by leakage from ...

...tv. count the LED flashes 1st digit short pause 2nd digit long pause, repeats. The red status lamp indicates there is no communication between the format board and the DMD board (light engine). The ...

...Mitsubishi 52525 has a flashing red status light. I have been working with Sears on a repair only to find that whatever they replace does not seem to fix the problem. the flashing has a pattern: ...

...Mitsubishi 65" DLP HDTV, yesterday I turned the TV off by using the button on the panel, 5 mins later i went to turn it on and it did, but no picture. But yet there was audio, then the status LED ...

...Mitsubishi WD-52327. The TV turns on and stays on for 30 sec to 3 minutes. Then the TV shuts off, no picture, no audio and status indicator flashes red 3 short times and then one long red flash and ...

...Mitsubishi WD-73736 TV had spots on the screen. I called and they said it was the dlp chip. So, i bought that and replaced the DLP. When, I turned on the tv, the red status light occurred. Red status ...

...Mitsubishi TV and it is blinking 6 red and 1 yellow can u help me to see what is wrong . If the status LED shows a consistent green light it means that the power is on, on the TV. ... If the status ...

...Mitsubishi+dlp+tv+status+light+blinks+6+red+1+orange Make the 2 digit error code come up https://www.diyforums.net/mitsubishi-wd-65737-dlp-tv-error-codes-13203.html ...