Questions & Answers for: mile club

1996 dodge ram conversion van 190,000 miles cuts off while driving. Do I need a tune up? And when do I know when to change the fuses? it may need a tune up they recomend 1 every 100,000 miles and ...

I have been told that the gasket on the throttle body needs to be replaced. The engine has 108,000 miles. Is this the real problem and how much of task is to to replace the throttle body gasket? I do

...i relied on past expirence with my 1983 BMW R100rs that bike has one million,three hundred thousand miles so far.when the volt meter increases while riding the problem is voltage regulator remove and ...

How to volvo v50 particle trap oil top up at 36000 miles when volvo v50 2.0d requires service at 36000 miles it requires the particle trap to be to be topped up with oil (EOLYS) how do i do this and ...

...club van with dual tanks. have installed both intank pumps, new selector valve, new external pump and cleaned tank. will run a couple of mile on rear tank and then shuts down, switch to front runs ...

...i went to sams club came out and it took 3 times turning over to start vehicle it ran fine for 30 miles i stopped again and had alot of trouble starting again when i came out of sams club i noticed ...

mhty 1999 dodge dakota club will run right for a few miles and start cutting out and repeat this over and over My dodge dakota club will crank and run fine for a few miles and start missing really bad

When I shift my V10 Dodge 2500 into reverse it hesitates for a few seconds then kinda slams in if I raise the rpms.Italso does it in drive and until it gets warm it will slip in drive. 150000 miles ...

...mile club and was nearing 400,000 and the odometer and trip meter quit working. ironically, the dash lights went out also .other instruments are working. 1989 Volvo 240 dl, serviced and maintained ...

Life Fitness Club Series+ treadmill, miles to kilometers? Hello, my building got some Life Fitness Club Series+ treadmill, but they are in miles. How to change to Kilometers? I've read the manual, ...