Questions & Answers for: Amana microwave interior paint

...interior (CAVITY) of a Microwave if it is a Combination Convection/Microwave Oven. The Convection Oven can reach temperatures of 400+ degreesF. This Temperature would MELT the paint off a painted ...

...Microwave Where is the light bulb located inside of the oven? Interior light bulb is located behind the grill, above door. It requires removing 3 or 4 screws to remove grill. I have same problem. I ...

interior of the microwave. Be sure to put all the screws back in the right holes, since some may be special grounding screws. Bulbs can be had in most grocery stores, hardware stores, home improvement

...microwave. Lately, it has begun sparking intermittently between the door and the floor. There looks to be a thin spot in the coating on the floor right at the bend on the edge near the door opening. ...

rust on outside of freezer door -- is there an epoxy or white coating to cover over the rust? You can clean off using a green scrubbing bad and some brasso all at wall mart then buy a can of ...

...a small fan in the back of the space to assist the microwave from overheating. The fan in the microwave only circulates air in the interior of the mvave. Please rate my help++++Thanks for using ...

...would explain the arcing. There is a special white enamel paint that is designed for microwave ovens that needs to be applied. The manufacture would have it and possibly the appliance repair

The motor will not work. The interior light comes on, but the turntable does not go around. The cook time counts down, but no cooking occurs. the turn table motor could have failed, but the counting ...

was working then made a raspi noise now nothing works Sounds like you might have a problem with metal in the oven. Look inside the oven including the "ceiling" and see if the finish has worn off, ...

...paint to repair microwaves for this issue or else just dispose of the microwave. If the inside is good remove all the screws and remove the cover. Replace the fuse. If the magnetron was making louder ...