Questions & Answers for: KitchenAid micro oven faults

...trim under micro; above oven, 2 more screws behind that grill will release micro from supportthat should free it up enoug to slide foward 6 or 8 inches( the bulb is ontop of the cavity) good

...micro wave stop working f-2 is on screen Possibly a keypad short or motherboard fault if it is a KitchenAid microwave. Beware if you have a KHMS155LSS model, a Keypad short can and will cause the ...

...oven/micro combo KEMS377GBL0. Think part # is 4450920. How to remove & replace (from front, rear or which side)? Looks like it may be the stirrer blade that is making that noise. I think you are ...

micro wave not heating water Hi, Here is a tip that will help you to figure out what is wrong with your Microwave Oven.... Basic Microwave Oven Troubleshooting Tips heatman101 =\\\\\\\

...Micro/Oven combo is not heating. The microwave has worked well ever since we installed it about 3 months ago but the oven does not heat up. Everything works on the control panel. The fan runs, the ...

...oven built in w/mw When I try to start the micro wave the indicator says DOOR and the microvave will not work or start. Check and replace as needed the door switches/catches. how did u fix the door ...

...when not in use. Getting it to work is difficult because if it is in its "beeping" mode you cannot get the buttons to respond RELAY & MICRO SWITCH OF OVEN TO BE CHECKED,MAY BE

and stops in 2 second intervals The microwave sounds like it has keypad control problem, behind the pad is the micro-controller board which controls vital areas of the oven, it needs to be checked out

We were using the 10 year old microwave last night for on high for about 30 minutes...all of a sudden a fan came on. I shut the microwave off and the fan continued. When the fan shut off I figured the

the microvave oven has "door" in the display and the microwave doesn't work Then one of the micro switches either has failed or has slid out of position