...meter and get a reading on the stator, I don't know the values on a dyna, but you should get a reading at idle and it should climb as you rev the motor. When my sporster did this it turned out to be ...
Question about 2000 FXDWG Dyna Wide Glide
...meter, it should hold the same reading as off the bike. Try to start the bike, if it starts, check the battery again, now it should read 14v or a little more. Turn everything off and try to start it ...
...wrong colour wires together thanks jason GREEN is always ground, start there,you will need a volt meter a $10 Harbor freight or $29 Home Depot volt meter will work fine. set the dial or setting ...
Question about 2000 FXDWG Dyna Wide Glide
reading of 12.5 volts or more but little or zero amperage, the battery is faulty and must be replaced. AGM type batteries fall into this scenario more so than lead-acid batteries. All voltage readings
how do i test a starter to see if its any good test a starter Set your meter in ohms. That's the horse shoe looking icon. test with the stator unplugged. Take one meter lead and run to one wire and ...
Question about 2000 FXDWG Dyna Wide Glide
reading of 12.5 volts or more but little or zero amperage, the battery is faulty and must be replaced. AGM type batteries fall into this scenario more so than lead-acid batteries. All voltage readings
Question about 2000 FXDWG Dyna Wide Glide
reading of 12.5 volts or more but little or zero amperage, the battery is faulty and must be replaced. AGM type batteries fall into this scenario more so than lead-acid batteries. All voltage readings
...METER to resistance scale to measure the resistance of the sending unit. Place one probe on Y/W and the other probe on a good ground. a. If fuel tank is full, the reading should be 40 ohms. An empty ...
Usually answered in minutes!
230 Questions
114 Questions
107 Questions
104 Questions
30 Questions