...above it, there's a single wire connection. Disconnect this wire and insert a test light or a volt meter into the wire. Turn the switch on and press the start button. You should see the test light ...
...you don't have a parts store that will do this for you, charge your battery fully. Then put a volt meter across the battery terminals, red meter lead to positive, black meter lead to negative. The ...
...need 12.5 volts or better after charging. 3. Hook up battery positive cable, then with your multimeter on the milliamp scale connect one lead to the negative battery post and the other lead to the ...
...need 12.5 volts or better after charging. 3. Hook up battery positive cable, then with your multimeter on the milliamp scale connect one lead to the negative battery post and the other lead to the ...
Question about 2010 FLHX Street Glide
...all connections are clean and tight especially the negative cable at both ends. 4. Hook up volt meter to battery and start engine, if meter falls below 9.5 v replace battery. 5. With engine ...
...meter quits reading zero and reads infinity and there or very close by is your short. For a wiring diagram go to: http://www.stcharlesharleydavidson.com/OEMpartfinder.htm# enter your year and model ...
Question about 2006 FLHX Street Glide
...meter reading should be 7-14 ohms and if the tank is empty the meter resistance reading should be 74-95 ohms resistance and a half full tank meter resistance reading will be approximately 30-38 ohms. ...
meter reading. The meter will read the voltage dropped or the difference in potential between the source and the destination. An ideal circuit voltage drop reading would be 1 volt or less. If there is
meter reading. The meter will read the voltage dropped or the difference in potential between the source and the destination. An ideal circuit voltage drop reading would be 1 volt or less. If there is
Question about 2007 FLHX Street Glide
...on 2007 street glide Oil light switch is a normally closed unit so first off test with an ohmmeter to see if there is an open which would not complete the circuit not allow the light to ...
Usually answered in minutes!
644 Questions
133 Questions
72 Questions
82 Questions
68 Questions