Questions & Answers for: Harley Davidson Bullet 125 how to take a meter reading

I've checked with an Ohm meter and have continuity I've checked with an Ohm meter and have continuity through the stator winding and also to ground. I am assuming the stator is bad, if I'm ...

...need 12.5 volts or better after charging. 3. Hook up battery positive cable, then with your multimeter on the milliamp scale connect one lead to the negative battery post and the other lead to the ...

battery light engine light and reds key is on tach and speedometer not working tach and speedometer not working battery light and engine light and red key are on the lights on these gauges will not go

how to read engine codes on 2009 harley touring I have a 2008 Road King, so I imagine the method to retrieve the codes would be the same. Retrieve fault codes:With engine run/stop switch in the RUN ...

on a 09 ultra classic what is the proper oil pressure? 10 different people give ten different answers. large variation on oil pressure between hot and cold engine. I realize pressure will drop as ...

2011 FLHTCU brakes rear brake caliper drag's has been bleed , dis assembled cleaned and re-assembled Hi Anonymous, I read some where Harley had an issue with some master cylinder rubber components

throttle flhtcu My husband has an '09 FLHTCU and yesterday, while riding, the bike lost power and wouldn't go over 20 mph. He has always done his own repairs to HD's, but this is the first fuel ...

...reading is not zero you will need to either zero it if your meter allows you to do that OR write down or otherwise remember the number and subtract it from the reading you get from the wire test or ...

..."INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary. 4. Hook up battery positive cable, then with your multimeter on the milliamp ...

..."INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter. 4. Bank angle sensor needs a reset or is faulty. 5. FOB battery low or dead. 6. Faulty ...