Questions & Answers for: Suzuki how to take a meter reading

...reading now! If the meter shows a discharge when you rev it up the Stator is Bad. If it shows over 16 volts the regulator rectifier is bad and needs replacing. It would be overcharging and burning or ...

meter,take a reading across the battery at rest(key off)should be about 12.8-13.2v.start the bike and take a reding across the battery if the bike is charging properly the meter should read between 13

tests for throttle position sensor Hi You can test the sensor with an ohm meter . Unplug the conecter from the sensor . There are three connecter pins . The top being one and the bottom three. With ...

...spark plug as plugs can fail under load and cause this? if no improvement then I would get a multi meter and test resistance readings on your stator connection leads and also check resistance on

...reading should be Infinite. With your meter on the same setting, place your multimeter positive lead on the regulator ground wire or to the regulator directly, and then place your meter negative lead ...

...reading should be Infinite. With your meter on the same setting, place your multimeter positive lead on the regulator ground wire or to the regulator directly, and then place your meter negative lead ...

Electrical. All lights off when key is on. When I measure voltage directly on battery, meter reads 14 volts. When I turn key to on, nothing lights up and meter reads 0 volt. Turning key back to off ...

...reading that'll be normal. If it checks out then your next culprits would in all likely hood be your regulator. Hook up your meter to your battery red on red black on black. Fire up the bike and rev ...

...swift speedo meter?? anything to stop meter reading or rewind meter reading, help would be appreciated ! Why would you need to? If its all electric then its locked in the memory. It's *******

...reading should be Infinite. With your meter on the same setting, place your multimeter positive lead on the regulator ground wire or to the regulator directly, and then place your meter negative lead ...