...meter in dc volts.in the range of at least 20 volts dc .. put the red lead in the positive "+" terminal of the battery and the black lead to the negative "-" terminal of the battery. start the engine ...
...meter reading will do the same. Run it from stop to wide open, slowly & steadily, and back the same way a few times & observe the meter reading. If the meter goes up & down at a steady reading and ...
Question about 1981 GL 1100 Innerstate Gold Wing
meter lead to an AC lead , forward bias reading should be 0.3V-0.8V repeat for each AC lead.Now reverse the meter lead hookup, reverse bias readings should read OFL. To do the ground side.Attach black
They are probably blown. Here is instructions for testing a blown speaker. Get yourself an electric meter, like a multi meter they sell at your local Radio Shack. Set it to read ohms (impedance). Make
...reading stator is junk. Then test out put meter to ac-volts meter leads to stator leads start the bike should read 15-100 vac. Then as far as the reg/rec goes set meter to diode mode and place one ...
...spark from the coil everything else gets fire but the coil what could it be. you need to use multi meter to test resistance readings from the stator your owner manual or bike shop can tell you what ...
Question about 2010 Insight
I have an Honda Insight 2009. There's a HMMF and spanner sign on the meter in the center of the speedometer. Whats the problem. THere is a Japanese narration that I cannot read I have an Honda ...
...need 12.5 volts or better after charging. 3. Hook up battery positive cable, then with your multimeter on the milliamp scale connect one lead to the negative battery post and the other lead to the ...
Question about 2010 Insight
meter to the pos and neg posts of the battery with all accessories and engine off, and take a reading. Then start the car and check the reading again it should be 1 - 3V higher then before. If its not
...meter lead on the +12vdc test the othe ouptput to the other sparkplugs you should get a similar reading. Test between the +12vdc and the - on the coil with the wires removed, you should read around 4 ...
Usually answered in minutes!
2,998 Questions
2,681 Questions
1,631 Questions
1,636 Questions
1,570 Questions