Questions & Answers for: Honda melt 5

Starter relay plug melted, bike wouldn't start. Cleaned melted plastic plug off and plugged in wires individually. Bike cranked and ran good. Felt of wires at relay and they were heating up. I shut ...

a mechanic quick like a bunny!! I had a Honda and it was doing the same thing, I finally managed to MELT the engine. Because of the aluminum - they are kinda easy to melt. SO ---- hurry !

What Would Make The Wire To A Gas Peddle Melt The Wire For The Gas Peddle Melted Why Would It Do That shorted or old wiring

after market pipes are melting the plastic intake part of the faring 4 into one vans and hines is there anyway to keep front piece from melting near oil cooler ,cooler does have its screen on but ...

motor runs fin but smoke major pouring out of generator end and circuit breaker will not stay on If you were drawing major power from generator, you may have fried capacitor or voltage regulator. Both

suspect window washer fluid is frozen,so how do I fix it? Wait for it to melt. Try driving around seeing if the heat in the engine bay would melt it, drain it all out by continuously using the washers

The plastic in the console is sticky like its melting. how do I fix melting plastic. sticky melting condition now can be easily treated, found this out on the youtude ...

1985 Gl1200 LE Stator wires melted at the plug in How do I deter-men which yellow wire goes were and how do I stop them from melting togeather again The yellow wires can go in any order (its does not ...

no brake light .turn signals or blinkers everything else fine whats up Most Honda bikes of the 1980's had small fuse boxes with 3-4 fuses at the most.  Usually 1 for ignition and charging, 1 ...

why is the 3 prong plug from the stater to the regulator melting This is 1984 vt700 and everything is charging the way it is suppose to but the lead from the stater to the regulator gets so hot it ...